Т³гж 5 – Pridiom Elite Series PWS247EL User Manual User Manual
Page 5
7
7
8
8
OPERATING INSTRUCTIONS
Airflow direction control
Adjust the air flow direction properly otherwise it might
cause discomfort or cause uneven room temperatures.
Adjust the horizontal louver using the remote controller.
Adjust the vertical louver manually or using the remote
controller(depending on models).
To set the vertical air flow(Up--Down) direction
Perform this function while the unit is in operation. Use the
remote controller to adjust the air flow direction. The
O
horizontal louver can be moved at a range of 6 for each
press, or swing up and down automatically. Please refer to
the REMOTE CONTROLLER OPERATION MANUAL
for details.
To set the horizontal air flow direction (left - right)
Move the deflector rod manually to adjust the air flow
in the direction you prefer.
IMPORTANT:Do not put your fingers into the panel of
blower and suction side.
The high-speed fan inside may
cause danger.
For some models, the vertical louver can be adjusted
by using the remote controller. Please refer to the
REMOTE CONTROLLER OPERATION MANUAL
for details.
Do not operate the air conditioner for long periods with
the air flow direction set downward in cooling or
dehumidifying mode. Otherwise, condensation may
occur on the surface of the horizontal louver causing
moisture to drop on to the floor or on furnishings.
When the air conditioner is started immediately after it
was stopped, the horizontal louver might not move for
approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug power for a few seconds,then restart
the air conditioner.
Do not operate unit with horizontal louver in closed
position.
CAUTION
,,
,,
,,
,,
OPERATING INSTRUCTIONS
NOTE: This manual does not include Remote Controller Operations, see the
<
Operating temperature
Manual switch
Range
Range
Deflector rod
КЦ
¶¯
¿Ш
ЦЖ
°´
The manual switch is on the bottom
of the unit as shown in the picture.
One press of the manual switch will
lead to the forced AUTO operation. If press
the button twice within five seconds, the unit
will operate under forced COOL operation.
This switch is used for testing purposes
only. You had better not choose it.
To restore the remote controller operation,
use the remote controller directly.
CAUTION:
1
2
NOTE: The unit must be turned off before
operating the manual switch. If the unit is
operational, continue pressing the manual
switch until the unit is off.
Manual operation
Mode
Temperature
Room temperature
Outdoor temperature
1. Optimum performance will be achieved within these operating temperatures.If air
conditioner is used outside of the above conditions, certain safety protection features
might come into operation and cause the unit to function abnormally.
2. If the air conditioner runs for a long time in cooling mode and the humidity is high(over
80%)
, condensed water may drip out of the unit. Please sets the vertical air flow louver to
its maximum angle (vertically to the floor), and set HIGH fan mode.
Suggestion: For the unit adopts an Electric Heater, when the outside ambient temperature
O
O
is below 0 C(32 F), we strongly recommend you to keep the machine plugged in order to
guarantee it running smoothly.
NOTE:
Cooling operation
Heating operation Drying operation
-15 50 5 122
For the models with low
temperature cooling system
0 50
32 122
-15 30
5 86
0 50
32 122
O
O
17 C~32 C
O
O
(62 F~90 F)
O
O
0 C~30 C
O
O
(32 F~86 F)
O
O
10 C~32 C
O
O
(50 F~90 F)
Units are equipped with a switch to run emergency operation mode. This switch is used for
manual operation in case the remote controller fails to work or maintenance necessary.