Pridiom Solar Series User Manual User Manual
Page 6
Cleaning the Grille, Case and Remote Controller
A cloth dampened with cold water may be used
on the indoor unit if it is very dirty. Then wipe it
with a dry cloth.
Do not use a chemically treated cloth or duster to
clean the unit.
Do not use benzine, thinner, polishing powder, or
similar solvents for cleaning. These may cause
the plastic surface to crack or deform.
Never use water hotter than 40 C/104 F to clean
the front panel, it could cause deformation of
discoloration.
O
O
CAUTIONS
CARE AND MAINTENANCE
Care and maintenance
NOTE: Supply power must be disconnectd before
cleaning the indoor unit.
IMPORTANT: Never use volatile substances(such as
gasoline or alcohol) to clean the panel.
Filter Handle
Cleaning the air filter
OPERATING INSTRUCTIONS
How the air conditioner works
1 hour
1 ho ur
Set
Temperature
Set
Temperat ure
Cooling
Heating
SLEEP operation
1 hour 1 hour
SLEEP operation
7 hours timer off
7 hours timer off
AUTO operation
SLEEP operation
DRYING operation
Optimal operation
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating(cooling/heating
models only), or fan only operation depending on what
temperature you have selected and the room
temperature.
The air conditioner will control room temperature
automatically round the temperature point set by you.
If the AUTO mode is uncomfortable, you can select
desired conditions manually.
When you push SLEEP button on remote controller
during cooling, heating(cooling & heating models only),
or AUTO operation , the air conditioner will
automatically increase (cooling) or decrease (heating)
per hour for the first 2 hours, then hold
steady for the next 5 hours, after that it will switch off.
This characteristic maintains both enery saving and
comfort in night operation.
The fan speed will be automatically controlled under
dry operation.
During the dry operation, if the room temperature is
lower than 10 C(50 F), the compressor stops operation
and restarts until the room temperature is above
12 C(54 F).
To achieve optimal performance, please note the
following:
Adjust the air flow direction correctly so that it is not
directed on people.
Adjust the temperature to achieve the highest comfort
level. Do not adjust the unit to excessive temperature
levels.
Close doors and windows on COOL or HEAT modes,
or performance may be reduced.
Use TIMER ON button on the remote controller to
select a time you want to start your air conditioner.
Do not put any object near air inlet or air outlet, as the
efficiency of the air conditioner may be reduced and
the air conditioner may stop running.
Clean the air filter periodically, otherwise cooling or
heating performance may be reduced.
Do not operate unit with horizontal louvre in closed
position.
O
O
O
O
A clogged air filter reduces the cooling efficiency
of this unit. Please clean the filter every month or
more often if necessary.
1. Push the front panel up straightly, then lift it
upward to an angle of about 20 , do not force to
open it more larger.
2. Use the panel brace to support the front panel
and remain it open as shown in the picture.
3. Take hold of the handle of the air filter and lift it
up slightly to take it out from the filter holder,
then pull it downwards.
O
3. Remove the AIR FILTER from the indoor unit.
Clean the AIR FILTER with a vacuum cleaner
or water, then dry it up in cool place.
.
Push up straightly
Panel
brace
Open the pa nel to an ang le of 20 , lift
the panel brace up to support the panel
and remain it open.
O
PDF created with pdfFactory Pro trial version