Plastec Adjustable Dampers - Manual (Page 18)

PL ASTEC VENTILATION, INC.
Installation, Operation & Maintenance Manual
ILLUSTRATIONS
ROOF UNIT 15 - ROOF UNIT 30 KIT ASSEMBLY
1) Components of Roof Kit: Roof Curb Cap, Motor Cap, Cap Bracket, Exhaust Guard
2) Place the cap bracket on the motor with the screwing inserts upwards.
3) Fix the motor flange.
4) Place the O-ring seal.
5) Place the impeller.
6) Push in the impeller.
7) Screw the hub cap on the motor shaft.
8) Install the hub cap.
9) Place the roof curb cap O-ring seal.
10) Place the roof curb cap on the housing.
11) Screw the roof curb cap to the housing.
12) Turn over the housing. Reinforce the base before placing the roof curb cap to support.
13) Place the motor/impeller part.
14 -17) Screw the motor flange and the cap bracket on the housing indicated in the pictures.
18) Do the correct wiring between the switch and the motor, respecting tension.
19) Screw back on the terminal box lid.
20-21) Place the motor cap and secure with screws.
22-24) Attach switch with screws on the flat side of the motor cap.
25) Place the exhaust cap on the outlet and attach with 4 screws.
26) Finished Assembly.
– 17 –
July 2012