Miller Compass 15 - Manual (Page 11)

The Compass 15 Fluid Head can be stored for extended periods;
Miller recommends storage in a Miller Soft Case and the
following:
• Remove battery.
• Clean the external surfaces.
• Keep in a dry place away from direct sunlight.
• Loosen off PAN & TILT LOCK.
Spare Parts and Accessories
ITEM ITEM NO.
Battery P7715
Camera plate Assembly #1204
(Including 3/8” + 1/4” screws and 1/4” + Pin Carriage)
Camera screw 3/8” P0037
Camera screw 1/4” P0036
1/4” + pin carriage #493
Standard Pan Handle assembly (incl. Handle Clamp) # 680
Standard Pan Handle # 689
Soft Case # 876
Clamp nut P7850
Warranty
Please refer to warranty card for complete details.
Miller Authorised Service Agents must carry out all service and
repair work. Failure to observe this requirement may void warranty.
It is advisable to notify Miller or a Miller Authorised Service Agent
if a change of performance is observed as a result of dropping or
rough usage. For information regarding sales and service of Miller
products or for your nearest Miller representative please contact
us via our website or at the following:
MILLER CAMERA SUPPORT EQUIPMENT
30 Hotham Parade, Artarmon, Sydney, NSW 2064 Australia
Tel: +61 2 9439 6377
Fax: +61 2 9438 2819
Email: [email protected]
MILLER CAMERA SUPPORT (LLC) USA
218 Little Falls Road, Cedar Grove, New Jersey 07009-1231 USA
Tel: (973) 857 8300
Fax: (973) 857 8188
Email: [email protected]
MILLER FLUID HEADS (EUROPE) LTD.
Unit A2, Ford Lane Industrial Estate
Ford Lane, Ford, West Sussex BN18 0DF, United Kingdom
Tel: +44 (0)1243 555255
Fax: +44 (0)1243 555 001
Email: [email protected]
Website - www.millertripods.com
Storage Service, Sales and Support
10