Mercedes-Benz SLK-Class 2005 Owners Manual - Manual (Page 267)

267
Controls in detail
Useful features
Step 3:
̈ Hold the end of hand-held remote
control transmitter 6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping indicator lamp 4 in view.
Step 4:
̈ Using both hands, simultaneously
press hand-held transmitter button 5
and desired integrated signal transmit-
ter button (1, 2 or 3). Do not re-
lease the buttons until completing
step 5.
Indicator lamp 4 on the integrated re-
mote control will flash, first slowly and
then rapidly.
Step 5:
̈ When indicator lamp 4 flashes
rapidly, release both buttons.
Step 6:
̈ Press and hold the just-trained inte-
grated signal transmitter button and
observe indicator lamp 4.
If indicator lamp 4 stays on constant-
ly, programming is complete and your
device should activate when the inte-
grated signal transmitter button is
pressed and released.
Step 7:
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
i
The indicator lamp 4 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.
i
If the indicator lamp 4 flashes rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the “rolling code” feature.