Kendon STAND-UP BIKE LIFT User Manual
Page 6
714‐630‐7144
www.KendonUSA.com
- 4 -
Operating Instructions
Using Your Kendon Stand-Up™ Bike Lift
Before Use
1) With ram fully retracted, locate and remove the oil filler plug. Insert the
handle into the handle sleeve, and then pump 6 to 8 strokes. This will
help release any pressurized air which may be trapped within the
reservoir. Ensure the oil level is just below the oil filler plug hole.
Reinstall the oil filler plug.
2) Check to ensure that the pump operates smoothly before putting into
service. Lubricate as instructed in Maintenance Section.
3) Inspect before each use. Do not use if bent, broken or cracked
components are noted.
Loading
1) Lay your Kendon Stand Up™ Bike Lift lying horizontally on the ground.
Ensure that it is fully retracted (e.g., ensure that the piston on the jack
itself is fully retracted – as with any air-over-hydraulic jack, it can
appear to be fully retracted, but can have a small amount of travel
remaining). To do this, simply push down on the Rail to confirm that
the lift is fully lowered. Fold out the rear section of the Rail Assembly.
2) Insert the loading ramp into the rear section of Lift as shown below:
3) The ramp is now securely attached and extends out from the back of
the folding section of the Lift.
4) Ensure the wheel chock on the rail is in the open position. The wheel
chock is in the open position when the wheel chock is rotated towards
the rear of the rail and the wheel chock channel will receive the front
tire of your motorcycle when it is loaded onto the rail.
5) CAUTION: You must check to ensure that the wheel chock will not
contact fender, fairing or other parts of your motorcycle BEFORE
loading. The wheel chock is designed to accommodate a variety of
motorcycles, but Kendon is not responsible to ensure that the wheel
chock will fit any particular motorcycle. Measure clearance BEFORE
use.
714‐630‐7144
www.KendonUSA.com
- 13 -
Warranty Information
Please fill in the required information and return by mail or facsimile to:
Kendon Industries, Inc.
Warranty Department
3707 East La Palma Avenue
Anaheim CA, 92806
(714) 630 7132 Facsimile
Customer:
Address:
Telephone:
E-Mail:
Store
Where
Purchased:
Store
Address:
Date
of
Purchase:
Do you have other Kendon Products?
Would Like Information on Other Kendon Products?