Jeep 2015 Grand Cherokee - Diesel Supplement - Manual (Page 29)

Oil Change Reset Procedure
1. Without pushing the brake pedal, push and release the
ENGINE START/STOP button and place the ignition
to the ON/RUN position (do not start the engine).
2. Fully push the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pushing the brake pedal, push and release the
ENGINE START/STOP button once to return the
ignition to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
Fuel Filter Life Reset
The cluster will display the “Fuel System Service Re-
quired – See Dealer” or “Service Fuel Filter” message
when the fuel filter maintenance life is less than 5%. To
verify if this is a fuel filter change event, go to the “Fuel
Filter Life” screen in the “Vehicle Info” menu. When this
message appears, dealers should replace the fuel filters.
NOTE:
Use the steering wheel DID controls for the
following procedure(s)
1. Without pushing the brake pedal, cycle the ignition to
the ON/RUN position (do not start the engine.)
2. Push and release the DOWN arrow button to scroll
downward through the main menu to “Vehicle Info”.
3. Push and release the RIGHT arrow button to access
the ”Fuel Filter Life” screen.
4. Push and hold the OK button for one second to access
the ”Fuel Filter Life Reset” screen.
5. Push and release the DOWN arrow button to select
“Yes”, then press and release the OK button to select
reset of the Fuel Filter Life.
3
UNDERSTANDING YOUR INSTRUMENT PANEL 27