beautypg.com

Speed control, Cruise on/off, Accel/decel – Jeep 2013 Compass - User Guide User Manual

Page 25: Resume, Cancel, Operating your vehicle

background image

SPEED CONTROL

• The Speed Control switches are located

on the steering wheel.

Cruise ON/OFF

• Push the ON/OFF button to activate

the Speed Control.

• CRUISE

will appear on the instru-

ment cluster to indicate the Speed
Control is on.

• Push the ON/OFF button a second

time to turn the system off.

SET

• With the Speed Control on, push and

release the SET – button to set a desired
speed.

Accel/Decel

• Once a speed is set, pushing the RES + button once or the SET – button once will

increase or decrease the set speed approximately 1 mph (2 km/h).

• Push and hold the RES + button to accelerate in 5 mph (8 km/h) increments or

push and hold the SET – button to decelerate in 5 mph (8 km/h) increments;
release the button to save the new set speed.

Resume

• To resume a previously selected set speed in memory, push the RES + button and

release.

Cancel

• Push the CANCEL button, or apply the brakes to cancel the set speed and

maintain the set speed memory.

• Push the ON/OFF button to turn the system off and erase the set speed memory.

WARNING!

• Leaving the Electronic Speed Control system on when not in use is dangerous.

You could accidentally set the system or cause it to go faster than you want. You
could lose control and have a collision. Always leave the Electronic Speed
Control system off when you are not using it.

• Electronic Speed Control can be dangerous where the system cannot maintain a

constant speed. Your vehicle could go too fast for the conditions, and you could
lose control. A collision could be the result. Do not use Electronic Speed Control
in heavy traffic or on roads that are winding, icy, snow-covered or slippery.

OPERATING YOUR VEHICLE

23