Before you begin programming homelinkĥ, Before you begin programming, Homelink – Jeep 2012 Patriot - Owner Manual User Manual
Page 164
NOTE:
HomeLink
is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink
ா
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink
system.
Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink
buttons (I and III) for up 20 seconds or until the red
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink
for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
HomeLink
Buttons/Sunvisor/Headliner
162
UNDERSTANDING THE FEATURES OF YOUR VEHICLE