Jeep 2012 Compass - Owner Manual - Manual (Page 270)

NOTE: If the audio device battery is completely dis-
charged, it may not communicate with the iPod ௡/USB/
MP3 control system until a minimum charge is attained.
Leaving the audio device connected to the iPod
௡/USB/
MP3 control system may charge it to the required level.
Using This Feature
By using iPod cable or external USB device to connect to
USB port:
• The audio device can be played on the vehicle’s sound
system, providing metadata (artist, track title, album,
etc.) information on the radio display.
• The audio device can be controlled using the radio
buttons to Play, Browse, and List the iPod ௡ contents.
• The audio device battery charges when plugged into
the USB/AUX connector (if supported by the specific
audio device)
Controlling The iPod
ா Or External USB Device
Using Radio Buttons
To get into the iPod
௡/USB/MP3 control mode and access
a connected audio device, either press the “AUX” button
on the radio faceplate or press the VR button and say
ЉUSBЉ or ЉSwitch to USBЉ. Once in the iPod௡/USB/MP3
control mode, audio tracks (if available from audio
device) start playing over the vehicle’s audio system.
Play Mode
When switched to iPod
௡/USB/MP3 control mode, the
iPod ௡ or external USB device automatically starts Play
mode. In Play mode, the following buttons on the radio
faceplate may be used to control the iPod
௡ or external
USB device and display data:
• Use the TUNE control knob to select the next or
previous track.
268 UNDERSTANDING YOUR INSTRUMENT PANEL