Jeep 2011 Wrangler - Owner Manual User Manual

Page 113

Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the

button until you hear a single beep, indicat-

ing that the active and hold status of the two calls have
switched. Only one call can be placed on hold at a time.

Conference Call
When two calls are in progress (one active and one on
hold), press and hold the

button until you hear a

double beep indicating that the two calls have been
joined into one conference call.

Three-Way Calling
To initiate three-way calling, press the

button

while a call is in progress, and make a second phone call,
as described under “Making a Second Call While Current
Call is in Progress”. After the second call has established,
press and hold the

button until you hear a double

beep, indicating that the two calls have been joined into
one conference call.

Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the phone far end, a call
on hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the

button until you hear a single beep.

Redial

• Press the

button to begin.

• After the “Ready” prompt and the following beep, say

“Redial”.

• The Uconnect™ Phone will call the last number that

was dialed from your mobile phone.

NOTE:

This may not be the last number dialed from the

Uconnect™ Phone.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

111