Jeep 2011 Compass - Owner Manual User Manual

Page 33

2. The transmission was in gear and the vehicle speed
returned to 0 mph (0 km/h).

3. The transmission is in NEUTRAL or PARK.

4. The driver’s door is opened.

5. The doors were not previously unlocked.

Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be
enabled or disabled as follows:

• For vehicles equipped with the EVIC, refer to “Elec-

tronic Vehicle Information Center (EVIC) — If
Equipped/Personal

Settings

(Customer-

Programmable Features)” in “Understanding Your In-
strument Panel” for further information.

• For vehicles not equipped with the EVIC, perform the

following procedure:

1. Close all doors and place the key in the ignition.

2. Within 15 seconds, cycle the ignition switch between
LOCK and ON/RUN and then back to LOCK five times
ending up in the ON/RUN position (do not start the
engine).

3. Within 30 seconds, press the power door UNLOCK
switch to unlock the doors.

4. A single chime will indicate the completion of the
programming.

5. Repeat these steps if you want to return this feature to
its previous setting.

NOTE:

• If you do not hear the chime it means that the system

did not enter the programming mode and you will
need to repeat the procedure.

• Use the Automatic Unlock Doors On Exit feature in

accordance with local laws.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE