Jeep 2010 Wrangler Unlimited - User Guide - Manual (Page 42)

RECREATIONAL TOWING
(BEHIND MOTORHOME)
Towing - Two-Wheel Drive
Models
• Recreational towing with all four
wheels on the ground is allowed ONLY
if the rear driveshaft is removed. See
your authorized dealer or refer to the
Service Manual. Towing with the rear
wheels on the ground while the
driveshaft is connected can result in
severe transmission damage.
WARNING!
If the driveshaft is removed, the
vehicle can roll even if the
transmission is in PARK, which could
cause serious injury or death.
• The parking brake must be firmly
engaged and the wheels chocked
during driveshaft removal and
installation. The parking brake must
remain engaged unless the vehicle is
securely and properly connected to the
tow vehicle, or the driveshaft is
completely reinstalled. See your
authorized dealer for proper driveshaft
removal and reinstallation procedures,
including flange orientation/alignment,
use of thread-locking compound,
proper bolt torque specifications, etc.
Towing - Four-Wheel Drive
Models
• Turn off engine and depress brake
pedal.
• Shift automatic transmission into
NEUTRAL or depress clutch pedal on
manual transmission.
• Shift transfer case to N (Neutral).
• Start the engine, shift into drive or 1st
gear and ensure there is no vehicle
movement.
• Shut off the engine, place ignition into
ACC position and shift automatic
transmission into PARK, manual
transmission into NEUTRAL.
• Apply the parking brake, attach vehicle
to tow vehicle and release the parking
brake.
• Disconnect negative battery cable.
• Refer to your Owner's Manual on the
DVD for further details.
BRAKE/TRANSMISSION
INTERLOCK MANUAL
OVERRIDE
• Your vehicle may be equipped with a
shift lock manual override.
• The manual override may be used in
the event that the shift lever should fail
to move from PARK with the Key Fob in
the ON position and the brake pedal
pressed.
• To operate the shift lock manual
override, perform the following steps:
• Turn the Key Fob to the ON position
but do not start the engine.
• Firmly set the parking brake.
• Using a flat-bladed screwdriver,
carefully remove the shift lock
manual override cover which is
located on the PRNDL bezel.
• Press and maintain firm pressure
on the brake pedal.
• Using a screwdriver, reach into the
manual override opening. Press and
hold the shift lock lever down.
• Move the shift lever into the
NEUTRAL position and start the
vehicle.
• Reinstall the override cover.
• Have your vehicle inspected by your
local authorized dealer if the shift lock
manual override has been used.
UTILITY
40