Jeep 2008 Patriot - Manual (Page 252)

Autostick
௡ operation is activated in the DRIVE position
by moving the shift lever side-to-side. Moving the shift
lever to the (+) side will activate Autostick
௡ and shift up
to the next higher manual ratio, unless you are already
operating in or near Overdrive, in which case 6th ratio
will be selected. In like manner, moving the shift lever to
(-) will activate Autostick
௡ and shift to the next lower
manual ratio. After Autostick ௡ is activated, the manual
ratio selected is displayed in the transmission ratio
display and tipping the shift lever to the (+) or (-)
direction will cause an upshift or downshift by one ratio.
Autostick ௡ is deactivated:
• By holding the shift lever to (+) momentarily
• When the shift lever is shifted out of DRIVE
• When in 6th position, touching the shift lever to the right
• When heavy Anti-Lock Brake System (ABS) applica-
tion is detected
Autostick
ா General Information
• If a ratio other than 1st is selected and the vehicle is
brought to a stop, the transaxle control logic will
automatically select the 1st gear ratio.
• If a low range is selected and the engine accelerates to
the rev limit, the transaxle will automatically select the
next higher ratio.
• If a downshift would cause the engine to overspeed, that
shift will not occur until it is safe for the engine. However.
the CVT will stay in the manually selected ratio.
• If the system detects powertrain overheating, the
transmission will revert to the automatic shift mode
and remain in that mode until the powertrain cools off.
• If the system detects a problem, it will disable the
Autostick
௡ mode and the transmission will return to
the automatic mode until the problem is corrected.
250 STARTING AND OPERATING