Lighting instructions – Louisville Tin and Stove CF654C-R User Manual
Page 11
CF357C, CF358C, CF557C, CF558C - I.I.D. PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control
system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.
STOP! Read the information on the safety label.
2.
Set the thermostat to its lowest setting.
3.
Turn off all electric power to the appliance.
4.
This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
5.
Remove cabinet door.
6.
Push in gas control lever slightly and slide right
to “OFF”.
7.
Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP!
Follow “B” in the information on the safety label. If you
don’t smell gas, go to the next step.
8.
Slide gas control lever left to “ON”.
9.
Replace cabinet door.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
“TO TURN OFF GAS TO APPLIANCE” and call your
service technician or gas supplier.
1.
Turn thermostat to it’s lowest setting.
2.
Turn off all electric power to the appliance if
service is to be performed.
3.
Remove cabinet door.
4.
Push in gas control lever slightly and slide right to
“OFF”. Do not force.
5.
Replace cabinet door.
MAXIMUM (HIGH)
PRESSURE REGULATOR
GAS CONTROL
LEVER
STEP PRESSURE REGULATOR
OUTLET (MANIFOLD)
PRESSURE T
A
P
NOTE: Lever
cannot be
moved to
“OFF” unless
it is
pushed in
slightly.
Do not
force.
MAXIMUM (HIGH)
PRESSURE REGULATOR
OUTLET (MANIFOLD)
PRESSURE T
A
P
STEP PRESSURE REGULATOR
GAS CONTROL
LEVER
NOTE:
Lever
cannot be
moved to
“OFF” unless
it is
pushed in
slightly.
Do not
force.
TO TURN OFF GAS TO APPLIANCE
Page 11