Habey FW-1044 User Manual

Page 3

www.habeyusa.com

Align notch in memory circuit with

corresponding guide on the memory slot.

Insert the memory circut at a 45° angle and

press the circuit flat and secure it to the

memory slot with an audible click on each

side of the memory slot.

Step 4 - Memory

Step 7 - Rack Mounting

Locate the included rack mount brackets

(ears). Mount the ears to the front side of the

enclosure by securing the ears to the side of

the enclosure with the included screws.

Your system is now ready. Connect the power cable to a power source and

press the power button on the front of the system.

Step 8 - Hardware Installation Complete

Step 6 - Themal Pad

Step 5 - VGA

If a VGA connector is needed, punch out the

VGA port on the rear of the chassis. Connect

the VGA head to the chassis and attach the

connector to the board pin headers.

Apply the themal pad on to the heat sink.