Habey BIS-6761 - Manual (Page 2)

www.habeyusa.com www.habeyusa.com
Install Guide
Unpack all package contents and inspect
each component. Make sure all included
parts and accessories are present.
Step 1 - Inspect Contents
Using a phillips head screw driver, remove
the four screws on the sides of the enclosure.
Step 2 - Remove Top Cover
In order to connect the 2.5” HDD to the HDD
port correctly in the next step, make sure the
HDD head is on the opposite side of the top
mounting screw hole.
Align notch in memory circuit with
corresponding guide on the memory slot.
Insert the memory circut at a 45° angle and
press the circuit flat and secure it to the
memory slot with an audible click on each
side of the memory slot.
Step 3 - Install RAM
Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.
Step 5 - Hardware Installation Complete
Step 4 - Install 2.5” HDD
Using a phillips head screw driver, remove
the three screws on the bottom cover.
Mount the HDD on the tray with the four
screws in the small plastic package.
Make sure the HDD port in the right position,
and then connect the 2.5” HDD head to the
HDD port.
Finally, tighten the three screws on the
bottom cover.