CAT Caterpillar Wheel Tractor-Scraper 627G - Manual (Page 21)

24 SEBU7858-03
Safety Section
Fire Extinguisher Location
g00687600
Illustration 26
Check lines, tubes and hoses carefully. Wear
Personal Protection Equipment (PPE) in order to
check for leaks. Always use a board or cardboard
when you check for a leak. Leaking fluid that is under
pressure can penetrate body tissue. Fluid penetration
can cause serious injury and possible death. A pin
hole leak can cause severe injury. If fluid is injected
into your skin, you must get treatment immediately.
Seek treatment from a doctor that is familiar with this
type of injury.
Replace the affected parts if any of the following
conditions are present:
• End fittings are damaged or leaking.
• Outer coverings are chafed or cut.
• Wires are exposed.
• Outer coverings are swelling or ballooning.
• Flexible parts of the hoses are kinked.
• Outer covers have exposed embedded armoring.
• End fittings are displaced.
Make sure that all clamps, guards, and heat shields
are installed correctly. During machine operation, this
will help to prevent vibration, rubbing against other
parts, excessive heat, and failure of lines, tubes and
hoses.
Do not operate a machine when a fire hazard
exists. Repair any lines that are corroded, loose
or damaged. Leaks may provide fuel for fires.
Consult your Caterpillar dealer for repair or for
replacement parts. Use genuine Caterpillar parts or
the equivalent, for capabilities of both the pressure
limit and temperature limit.
Ether
Ether (if equipped) is commonly used in cold weather
applications. Ether is flammable and poisonous.
Follow the correct cold engine starting procedures.
Refer to the section in the Operation and Maintenance
Manual with the label “Engine Starting”.
Do not spray ether into an engine if the machine is
equipped with a thermal starting aid for cold weather
starting.
Use ether in well ventilated areas. Do not smoke
while you are replacing an ether cylinder or while you
are using an ether spray.
Do not store ether cylinders in living areas or in the
operator compartment of a machine. Do not store
ether cylinders in direct sunlight or in temperatures
above 49° C (120.2° F). Keep ether cylinders away
from open flames or sparks.
Dispose of used ether cylinders properly. Do not
puncture an ether cylinder. Keep ether cylinders
away from unauthorized personnel.
Fire Extinguisher
As an additional safety measure, keep a fire
extinguisher on the machine.
Be familiar with the operation of the fire extinguisher.
Inspect the fire extinguisher and service the fire
extinguisher regularly. Follow the recommendations
on the instruction plate.
Consider installation of an aftermarket Fire
Suppression System, if the application and working
conditions warrant the installation.
i02370502
Fire Extinguisher Location
SMCS Code: 7000
Make sure that a fire extinguisher is available. Be
familiar with the operation of the fire extinguisher.
Inspect the fire extinguisher and service the fire
extinguisher regularly. Obey the recommendations
on the instruction plate.
The fire extinguisher may be mounted to the grab
handle that is located on the right platform near the
front of the engine hood. Do not block access to the
following items:
• handrails
• ladders