Gastroback 41127 Electrical Ice Crusher - Manual (Page 10)

23 22
aTTenTion: Do not use abrasive cleaners, cleaning pads, corrosive chemicals (disinfectants,
bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning, for this could damage
the surfaces. Always handle the entire appliance with care and without violence.
Dip the nylon washing brush in warm soapy water. Open the locking cap with your fingers
and move the nylon brush in circles to clean the feeding chute. rinse the brush with clear
water afterwards and repeat the procedure.
3. rinse the feeding chute with a little bit of clear, cold water.
4. take the ice container and empty it. Moisten a clean, soft cloth with warm soapy water and
wipe the surface of the appliance and the ice container.
5. Dry the appliance and all the units. Assemble the appliance.
sTorage
Always clean the appliance before storing (see ‘Care and Cleaning’). Ensure to store the
appliance where it is clean, dry and safe from frost, direct sunlight and inadmissible strain
(mechanical or electric shock, heat, moisture) and where it is out of reach of young children.
Place the appliance on a clean and stable surface, where it can not fall. Do not place any
hard or heavy objects on the appliance. to avoid touching the blade unintentionally, it is good
advice to store the blade in the container with the lid in place.
TrouBLe shooTing
If the feeding chute is overloaded or you filled in ice before you started the motor the motor
might stucks, stalls or run sluggish. Act upon the following instructions:
1. turn the appliance off and pull the plug out of the power outlet.
2. take the leftover ice out of the feeding chute. Act upon the following instructions:
warning: to avoid injury to persons and damage, never place your fingers or foreign
substance into the feeding chute while the appliance is still connected to the power outlet.
Always turn the appliance off and unplug the appliance before assembling/disassembling or
cleaning the appliance.
remove the ice container. hold the locking cap open with one hand and turn the appliance
upside down over the sink.
aTTenTion: turning the appliance around ensure that no water can run into the motor
housing. Dry the appliance before turning it if necessary. Carefully shake the appliance to get
the stucked ice cubes out of the feeding chute.
3. turn the appliance into the upright position, dry it and put the ice container in position.
4. Put the plug into the power outlet and turn the appliance on. the motor should run smooth
again. Otherwise return the entire appliance (including all parts and accessories) to an autho-
rised service centre for examination and repair.