Fat Shark Predator V2 - Manual (Page 5)

Fat Shark 5 RC Vision Systems
Controls
Brightness/contrast control: pressing left and right increases/decreases display
contrast. Press forward/back increases/decreases brightness.
RX power switch: The receiver module power is controlled by this switch. If
viewing video source via the AV cable; the RX module needs to be turned off to
avoid image conflict.
Channel select: Pressing channel up/down buttons will cause the channel to
incrementally increase/decrease. Audio beep sounds on channel change. A long
beep sounds on channel top and bottom limits.
Note: Fat Shark only guarantees compatibility with Fat Shark or ImmersionRC
transmitters.
CH1: 5740 MHz CH2: 5760 MHz CH3: 5780 MHz CH4: 5800 Mhz
CH5: 5820 MHz CH6: 5840 Mhz CH7: 5860 MHz
Low battery warning: Audio warning if input voltage drops below 6.8V
Volume control: each press of button increments volume up or down. Standard
earphones can be used with the Predator (not included).
Downlink Overview (Camera, TX, Power)
Downlink system comes preassembled and tested for plug/play with your aircraft.
Simply connect the balance lead of your 2S, 3S or 4S (7.4V - 16V) RC battery to
provide power to your Fat Shark Downlink and you are ready to fly.
The handy balance lead filters RC servo and motor noise from your RC pack for a
crisp, clear image.