Clarion DB179RGMP - Manual (Page 14)

13
English
DB178RMP / DB179RMP / DB179RGMP
Auto store
Auto store is a function for storing up to 6 stations
that are automatically tuned in sequentially. If 6
receivable stations cannot be received, a previ-
ously stored station remains un-overwritten at
the memory position.
1. Press the [BND] button and select the desired
band (FM or AM (MW/LW)).
2. Press and hold the [ ] button for 2 seconds
or longer. The stations with good reception are
stored automatically to the preset channels.
“A-STORE” will be displayed.
∗ If auto store is performed in the FM bands, the
stations are stored in FM3 even if FM1 or FM2
was chosen for storing stations.
Recalling a preset station
A total of 24 preset positions (6-FM1, 6-FM2,
6-FM3, 6-AM) exists to store individual radio
stations in memory. Pressing the correspond-
ing [DIRECT] button recalls the stored radio fre-
quency automatically.
1. Press the [BND] button and select the desired
band (FM or AM (MW/LW)).
2. Press the corresponding [DIRECT] button to
recall the stored station.
Radio Mode Operations
Preset scan
Preset scan receives the stations stored in preset
memory in order. This function is useful when
searching for a desired station in memory.
1. Press the [
] button.
2. When a desired station is tuned in, press the
[ ] button again to continue receiving that
station.
“ P-SCN” will be displayed and “SCN” indicator
lights in the display.
Note:
Be careful not to press and hold the [ ] button
for 2 seconds or longer, otherwise the auto store
function is engaged and the unit starts storing sta-
tions.
RDS Operations
RDS (Radio Data System)
This unit has a built-in RDS decoder system that
supports broadcast stations transmitting RDS
data.
This system can display the name of the broad-
cast station being received (PS) and can auto-
matically switch to the broadcast station with the
best reception as you move long distances (AF
switching).
Also, if a traffic announcement or programme
type is broadcast from an RDS station, no matter
what mode you are in, this broadcast is received.
Additionally, if EON information is received, this
information enables automatic switching of other
preset stations on the same network and inter-
ruption of the station being received with traffic
information from other stations (TP). This func-
tion is not available in some areas.
When using the RDS function, always set the ra-
dio to FM mode.
AF : Alternative Frequency
PS : Programme Service Name
PTY : Programme Type
EON : Enhanced Other Network
TP : Traffic Programme
∗ RDS interrupt does not function during AM radio
reception.
∗ When set receives RDS signal, and can read PS
data, PS appears in the display.
TA (Traffic Announcement)
In the TA standby mode, when a traffic announce-
ment broadcast starts, the traffic announcement
broadcast is received as top priority regardless of
the function mode so you can listen to it. Traffic
programme (TP) automatic tuning is also pos-
sible.
∗ This function can only be used when “TP” is lit in
the display. When “ TP” is lit, this means that the
RDS broadcast station being received has traffic
announcement programmes.