Evolution Engines EVOE0605 - Manual (Page 7)

7
Troubleshooting Guide
Engine Won’t Fire
• Glow starter not charged
- Charge glow starter
• Glow plug burnt out
- Replace glow plug
• No fuel is getting to the carburetor
- Check tank, fuel lines reversed
• The starter is reversed
- Reverse the polarity on the starter cables
Engine Quits Repeatedly
• Needles need adjusting
- See adjustment procedure
• Bad or old fuel
- Replace with fresh fuel
• Worn out glow plug
- Replace with new EVOGP1 super plug
Engine Runs Inconsistently
• Hole in fuel line
- Replace fuel line
• Bad or old fuel
- Replace with fresh fuel
Maintenance
After each flying session:
1. Fully drain the fuel from the tank.
2. Start the engine and run it until the fuel is
completely run out of the engine.
3. Try starting the engine three more times or until
it will no longer fire. This gets all the fuel out of
the engine.
At the end of every flying session, several drops (about
10) of after-run oil (Evolution Engine's Blue Block Rust
Inhibitor) should be applied into the venturi and the
engine should be flipped over for a few seconds with the
starter. This will prevent rust and corrosion.
Disp Bore Stroke Weight Crank K
Items (c.i.) (mm) (mm) (oz) (ISO) Cylinder Propeller
EVOE0365 .60 24.0 .21.5 12.7 1/4 X 28 ABC 12 x 6 or 13 x 4
Evolution Control Line Engine Specifications
Dimensions(mm) A B C D E F G H
EVOE0605 36 44 17.5 52.5 94 110 1/4 X 28 37
F
H
G A
D C
E = height
F = length
G = crankshaft thread size
H = muffler bolt spacing
B