beautypg.com

Programming sequence, Technical data, Changing the ignition timing – Evolution Engines 26GX User Manual

Page 11

background image

10

WARnIng! Use the ignition only in dry conditions

Use recommended number and type of cells for every ignition type

The product is specified for RC engines only (other use must be approved by the manufacturer)

Do not take off the plug cap if the ignition is on

Danger of electric injury (voltage over 20,000V)

Recharge ignition battery only outside the model

Because of possible interferences, ignition and battery should be placed at least 25 cm from the receiver

The manufacturer is not responsible for damages caused by not following the manual or by using the ignition for anything

other than RC engines. Guarantee is void if the high voltage (HV) cable or HV isolation is damaged, the pickup or batteries are

reversed, or the ignition box is opened.

Technical Data

* if battery test is enabled

Lite

Version

155 g

Weight

2x Li-Ion/Li-Po*

Power supply

6x NiCd / NiMH*
5x NiCd / NiMH
6.5V*

Minimal battery voltage*
Sleep mode after 90 seconds of engine inactivity
Battery level signalization *
Ignition goes off if engine runs counterclockwise
Choice of preignition curve

Preignition point

240º / 120º

Location of the magnet

600 mAh

Min. battery capacity

Never use ignition with plug cap removed from plug! Before first
flight, do a range check with running engine.

Programming Sequence

Low battery

Sleep mode

Short silencer

Long silencer

0

10

0

m

s

20

0

m

s

30

0

m

s

40

0

m

s

50

0

m

s

60

0

m

s

70

0

m

s

80

0

m

s

90

0

m

s

1

s

1.

1

s

1.

2

s

1.

3

s

1.

4

s

LED Blinking Types

light

dark

LED Blinking Indication

One short flash

per second

Sleep mode spark is blocked

Unplug battery and

reconnect it again

Type

Problem

Solution

changing the Ignition Timing

If using the battery test function

- Make sure plug cap is attached to the plug

- Turn on ignition and power up

- Wait about 90 seconds until sleep mode is active; LED will

begin flashing once per second

- If battery test is enabled (jumper is plugged) remove the

jumper from programming pins

- Wait about 3 seconds; a flashing sequence changes itself

- Unplug battery

- Plug jumper back (to enable battery test)

If not using the battery test function

- If battery test is disabled (jumper is removed), plug the jumper

to programming pins

- Wait about 3 seconds until flashing sequence changes

- Unplug battery

- Unplug jumper back (to disable battery test)

To change silencer type, repeat the procedure again:

short muffler ➭ tuned pipe ➭ short muffler, etc.

12912_EVO(26GXmanual).indd 10

3/3/08 12:01:00 PM