ETS-Lindgren HI-3638 ELV/VLF Electric Field Meter - Manual (Page 19)

www.ets-lindgren.com Battery Charger 19
5.0 Battery Charger
Setting the Voltage
Disconnect the battery charger from power
before changing the voltage setting.
Check the viewing window on the power entry module to verify that the
battery charger is set to the proper voltage for your AC power source. To change
the voltage setting:
1. Disconnect the battery charger from power.
2. Use a small screwdriver to loosen and remove the fuse assembly from
the power entry module.
3. Slide the small board located on the back of the fuse assembly from
right to left to remove it.