ETS-Lindgren 2110 Multi-Axis Positioning Systems (MAPS) - Manual (Page 8)

8 | Introduction
Part Description Part Number
Fiber optic cables, installation hardware, fiber optic
feedthrough connectors
110084
M ODEL 2115 M EDIUM D UTY MAPS
The Model 2115 medium duty MAPS is equipped with mounting plates to secure
EUT or a Specific Anthropomorphic Mannequin (SAM) phantom head up to
11.3 kg (25.0 lbs). The SAM phantom head for testing wireless handsets is
optional.
Part Description Part Number
Model 2115 Medium Duty MAPS
Includes:
• MAPS Turntable Assembly, part #111040
• Medium Duty Mast Assembly, part #111047-NNNN
Specify height as –NNNN; for example, 72 inches is
–7200 and 59.5 inches is –5950
2115-NNNN
Fiber optic cables, installation hardware, fiber optic
feedthrough connectors
110084
Standard Configuration
The MAPS includes a horizontal roll axis for mounting EUT. Each MAPS is built
according to the customer-specified height by reducing the vertical support
column to the appropriate length. The height of this axis must be specified when
ordering the unit. A motor drive at the base of the vertical support column, in
conjunction with the ETS-Lindgren Model 2090 Multi-Device Controller (or next
generation ETS-Lindgren controller, if applicable), controls the movement of the
unit.
Each MAPS is furnished with a 63-in (160-cm) diameter circular wood deck that
is bolted onto a motorized turntable. The deck has an opening for the vertical
support and access to the knobs that clamp the sliding carrier into a fixed
position.
The MAPS is equipped with two motor bases, one to control each rotational axis.
A 230 VAC 50 or 60 Hz single-phase receptacle is required to power each unit.
Current draw is less than 4 amps per motor base. The drive power for both
rotations is provided by the filtered 208–230 VAC, 50/60 Hz single-phase power
inside the chamber. Therefore, there is no need for power drive cables to
penetrate the shielded enclosure.