ETS-Lindgren 3186 Dual Stacked LPDA Antenna - Manual (Page 19)

www.ets-lindgren.com Mounting Instructions 19
Using the Stinger Mount
To stinger-mount the Model 3186 to a 7-TR, an ETS-Lindgren mast, or
an ETS-Lindgren 2x2 boom, you need a 108983 boom or
118947 boom. If you have a non-ETS-Lindgren or previous generation
EMCO positioning system, contact ETS-Lindgren for stinger mounting
options.
The Model 3186 includes a stinger that can be used to mount to a 7-TR, an
ETS-Lindgren mast, or an ETS-Lindgren 2x2 boom.
1. Thread the antenna feed or receiving cable through the center of the
boom so that the antenna connector emerges a few inches out of the
clamp end of the boom.
2. Loosen the two boom knobs at the end of the boom.
3. Connect the antenna cable to the end of the stinger.
4. Insert the stinger into the end of the boom.
5. Re-tighten the two boom knobs to secure the antenna into place.