Eden RS Combos - Manual (Page 5)

5
Semi-Parametric Equalizer – Allows you to dial in a specific frequency to
enhance or cut. This feature is especially useful for upright and acoustic bass
guitars that have a resonant frequency. Because we’ve included a bypass
switch, you can also use it to create a second tone that is available
instantaneously. (You’re welcome.) The frequency is adjustable from 40Hz
to 10KHz. The level can be adjusted +/- 15 dB. The control is FLAT when
the level control is at 12:00 position (straight up). ON/OFF Indicator
D.I. Selector – Allows the user to choose to send the D.I. either pre-EQ or
post-EQ.
Three Band Tone Controls – Divides the audio spectrum into three bands:
Bass, Mid, and Treble. The Bass and Treble controls are shelving type
filters. The Mid control is a band pass type filter. These controls give you a
broad general control of the tone shaping.
Master Volume – Controls the main stage sound level and the Head Phone
outputs.
Headphone Jack – Accepts a standard ¼ inch stereo or mono headphone
plug. It can also be used as a Master Output send to slave another amplifier.
DC Indicator – When lit, shows that the low voltage power supplies are
operating.
Mains On/Off Switch – This switch turns the system power ON or OFF.
The switch illuminates to indicate the presence of AC power present in the
chassis. This switch is prior to the fuse. The light in the switch may flicker
depending on local voltage conditions. This is normal and nothing to be
concerned about.
NOTE: The Mains Switch will illuminate even if the fuse is blown.
However, the DC Indicators will not illuminate if the fuse is blown.
IMPORTANT NOTE: When attached, the included lighted footswitch will
defeat the Front Panel controls for the Mute to Tune and Enhance Bypass
functions.