Eden DC-210XLT Metro - Manual (Page 6)

6
Compressor Defeat Switch – To defeat the Auto-Compression circuit,
depress this switch.
Compressor Indicator Light – Indicates compression is taking place.
Tone Control Section
Here’s where things are a bit different than Channel 1. This channel uses our
original 5-way semi-parametric EQ. These controls offer more tone shaping
options. The spacing allows the controls to interact smoothly and musically.
From left to right, the controls and switches are:
Bass – This traditional shelving tone control provides 15 dB of boost or cut
at approx. 35Hz. The control is flat in the 12:00 position.
Semi-Parametric Controls
There are three sets of semi-parametric controls. Each set has a Frequency
control (top knob) and a Level control (bottom knob). The Level controls
provide 15 dB of cut or boost. The control is FLAT in the 12:00 position.
From left to right, the Frequency controls have the following ranges:
30-300Hz 200Hz-2Khz 1.2-12Khz
Treble – This traditional shelving tone control provides 15 dB of boost or
cut at approx. 11KHz. The control is flat in the 12:00 position.
Master Level Control – Adjusts overall system output and stage loudness.
Headphone Jack – Accepts a standard 1/4-inch stereo or mono headphone
plug. It can also be used as a Master Output send to slave another amplifier.
Output Limit Indicator – Lights to indicate activity of the power amplifier
limiting circuit, which protects the speaker system from severe distortion.
The LED indicate that the amplifiers have reached their maximum output
level.
DC Indicator – When lit, shows that the low voltage power supplies are
operating.