Dyras BSSV-2218WF User Manual

Page 8

BSSV-2218WF

If the brush is turned outwards as shown in the diagram, the tool can be used for
cleaning delicate surfaces (e.g. curtains, shelves and books).

6. Using the narrow suction head

This suction head is designed for cleaning carpeted areas (e.g. between furniture) that cannot be
accessed by the wider attachment.

7. Using the air blower function

To use the air blower, insert the goose-neck pipe into the round outlet hole
(22) on top of the water tank cover.

MAINTENANCE AND CLEANING

Warning! Before you clean the appliance it must be switched off and the mains plug must

be removed from the wall socket.

• Clean the outside cover of the appliance with a damp, soft, lint-free cloth and then wipe the cleaned

surfaces with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the appliance dry
completely before re-using or storing it.

• When cleaning the appliance, never use solvent (acetone, benzole, petrol, alcohol, etc.) as these may solve the

casing material, or the internal parts of the appliance if they get into. Do not use cleaning agents with coarse
or grinding effect.

Maintenance and cleaning the filter unit

1. After use, always empty the waste water from the tank before cleaning the tank and the filter unit.

2. Remove the water tank as described in the ‚assembling and preparing’ section. Remove the filter unit (20) and

empty the tank. Wash it thoroughly by hand, using lukewarm water with a gentle liquid detergent, then rinse
it with clean water from the cold tap. Finally, dry it thoroughly.

3. Dismantle the filter unit as follows:

• Carefully pull back the lock that holds the filter frame in place, then lift off

the frame.

• Remove, wash and rinse all the components of the filter unit. Ensure they are

completely dry before reassembling them.

• Take care to adjust and position the components correctly when

reassembling them. Make sure the filter cartridge is correctly held in place
by the filter frame.

Notes:
You can remove stubborn dirt with a gentle liquid detergent. Rinse the components thoroughly afterwards.

Replacing the HEPA filter

A dramatic reduction in suction power is usually an indication that the
HEPA filter will need replacing. Only replace the filter when the machine is
unplugged.

• Remove the cover of the HEPA filter from the bottom of the appliance by

pressing both locking buttons at the same time.

• Remove the cover of the HEPA filter from the bottom of the appliance by

pressing both locking buttons at the same time.

Notes:
The filter tank will need to be replaced if it has become wet or dirty as a result of overfilling. If the tank has a small
amount of moisture it should be removed and dried thoroughly before being stored or used again.