Dyras PPM-227 - Manual (Page 7)

EN
PPM-227
7
USING OF APPLIANCE
Before use
• Unpack the appliance and remove all the packing materials.
• Examine the device to make sure it’s complete and has not suffered any damage. You should only use the
device if all parts are present and undamaged.
Battery replacement
• Carefully rotate the upper cover in a counter-clockwise direction by approx. 1/12 turn while holding the
peppercorn compartment.
• Remove the upper cover from the unit, and then also remove the plastic tube protecting the batteries.
• Remove the run-down battery and insert new ones, according to the indicated polarity. Please perform the
battery replacement carefully since the warranty of the device does not cover the failures caused by improper
battery replacement.
• Place the plastic tube back onto the battery compartment and the same with the upper cover onto the unit.
Fasten the upper cover by rotating clockwise.
Never dispose of the replaced batteries in the household waste, because they will endanger the
environment! Please use a dedicated waste container provided for this purpose or a collecting
station for disposing of used batteries!
Never throw the batteries in the fire, because they can explode.
Filling the peppercorn compartment
• Carefully rotate the upper cover in a counter-clockwise direction by approx. 1/12 turn while holding the
peppercorn compartment.
• Carefully pull off the compartment from the unit, and then fill it with salt or pepper.
• Replace the compartment back on the unit so that the pins on the unit fit in the holes on the compartment.
• Replace the cover element on the unit, and fasten it by rotating in clockwise direction.
• Adjust the desired grinding fineness level by means of the screw located on the bottom of the unit. Rotate
the screw towards the + mark for a coarser grind or towards the - mark for a finer grind.
• The appliance grinds while the power ON button is depressed.
Warning!
Never adjust the grinding fineness to such a degree that it blocks the shaft. When the shaft is
blocked, rotate the fineness adjusting screw toward the mark +. If grinding still fails to occur, do
not force it, but take the compartment off and clean the grinding head.
User'sManual PPM-227.indd 7 User'sManual PPM-227.indd 7 2012.10.10. 15:19:28 2012.10.10. 15:19:28