Dyras DBSC-437 - Manual (Page 4)

DBSC-437
6
EN
DBSC-437
7
Keep your environment clean! The used appliance cannot be disposed of with communal waste, as
it can pollute wildlife and severely endanger human health. At the end of its life please take it to a
locally approved competent recycling point for electric appliances for recycling or for environment
friendly disposal. Do not dispose of flat batteries with communal waste, but take them to a locally
approved recycling point. Flat batteries are hazardous waste that pollutes the environment if not
collected and disposed of in an environment friendly manner.
Please keep this instruction manual. If you give the appliance to anyone else, you must give them
this instruction manual, too!
MAIN COMPONENTS
1. Device housing
2. Removable transparent measuring bowl
3. On-off switch and taring button (ON/OFF/ZERO)
4. Unit selection push button (MODE)
5. LCD-display
6. Battery compartment
POWER SUPPLY
Power is provided by one CR-2032 3v battery
Notes
• The appliance can be energised only by batteries. Neither a mains connection, supply adapter nor supply
accumulator can be used for its power supply.
• Please use only batteries as specified in the instruction manual. Other batteries (other size or shape) cannot
be inserted in the appliance and it may become inoperable or damaged when used with batteries supplying a
different voltage.
Battery replacement
• A warning indication on the display appears when the battery requires changing.
Replace the batteries by following these instructions:
• Remove the battery holder cover
• Replace the exhausted battery with a new one, ensuring polarity alignment is correct. Please change the
battery carefully, because the warranty does not cover defects arising from incorrectly installed batteries.
• Attention! The appliance must not be disassembled, its casing must not be removed, or its repair attempted.
There are no parts inside the appliance that could be home repaired or used for any other purpose. In the
case of any defect of the appliance please have it repaired only by an authorised special service station. The
manufacturer does not undertake any warranty for any improper attempt at repair, or any intervention
performed by unauthorised persons.
Dear Customer,
All electrical and mechanical equipment needs to be cared for appropriately. It’s important to
note that using or storing the appliance in certain conditions may adversely affect its lifespan and
functionality. Always protect the appliance from the conditions listed below.
Using or storing the appliance in a wet, humid or damp environment can cause:
- deterioration and premature aging of the cover and electric insulation of the appliance,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause:
- greasy dust coatings on the mechanical and electrical elements and the casing of the appliance,
which could result in electrical contact failure or even complete breakdown, and could also
damage the plastic and rubber elements.
The effects of direct sunlight on the appliance can include:
- accelerated deterioration of the appliance casing and its plastic and rubber components,
damage to strength and other structural features. The appliance’s surface may become porous
and fragile, which may result in a safety risk.
Storing the appliance in cold or frosty environment may cause:
- damage to the plastic and rubber components; if they become fragile, this may result in a safety
risk.
- oxidation resulting from condensation, and corrosion of the metal components.
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:
- damage, deformation, softening or melting of plastic or rubber parts and casing elements, or
deterioration of electrical insulation.
Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. You are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.
User'sManual DBSC-437.indd 6-7 User'sManual DBSC-437.indd 6-7 2012.09.17. 11:25:59 2012.09.17. 11:25:59