Dynojet Wideband Commander Air/Fuel Ratio Monitor - Manual (Page 3)

I15-7012 Wideband Commander Air Fuel Ratio Monitor Installation Guide - 1
P
ARTS
L
IST
quantity description
1 Wideband Commander Module
1 Wideband Commander Software
1 Bosch LSU 4 Wideband Oxygen Sensor
1 Oxygen Sensor Cable
1 Power Supply
1 Power Supply Cable
1 USB Cable
3 Cable Ties
1 Dynojet Decal
S ETTING U P THE W IDEBAND C OMMANDER
1 Release the holding tabs by inserting a small
screw driver into the four back slots on the
Wideband Commander module.
2 Remove the back panel of the Wideband
Commander module.
3 Attach the O2 sensor wiring harness wires to
the screw terminal as shown in Figure B.
4 Replace the back panel. Verify the holding tabs
lock securely into the slots.
Note: Dynojet recommends securing the
sensor cable to the main wiring harness with a
cable tie for additional strain relief.
Fi
gu
re
A
Fi
gu
re
B