English – Clarion VT1000T User Manual
Page 16
6
1
English
Headphone components
POWER
VOLUME
OFF--ON
Power light
Power switch
Volume dial
Headphones
Installing batteries in the headphones
If this is the fi rst time you’re using the system, install batteries in the headphones.
Change the batteries when you begin to hear distorted audio that cuts in and out.
1. Rotate the left earpiece so the battery cover is
accessible.
2. Slide the battery cover down.
3. If replacing the batteries, remove the
discharged batteries.
Battery cover
Close-up of the left earpiece
4. Insert the new AAA batteries according to the
polarity marked inside the battery compartment.
5. Slide the battery cover back into place.
Batteries installed
Close-up with batteries
installed
Setting the volume
The volume control is on the headphones. Turn the volume dial up or down.
Note:
Some noise may be audible depending on the type of encoder
software used while recording. This noise is not caused by the
VR800B/VR1000B/VR1000T/VR1500B.
VT800B/VT1000B/VT1000T/VT1500B