Chamberlain WIRELESS GATE ACCESS RGAIPI - Manual (Page 4)

4
Troubleshooting
Indoor Intercom does not receive voice
transmission from Outdoor Intercom.
Check the batteries in both intercoms. Ensure the
Indoor Intercom is programmed to the Outdoor
Intercom. See Program Indoor Intercom to Outdoor
Intercom.
Indoor Intercom is not getting expected
transmission range.
Keep antenna vertical. Keep Outdoor Intercom away
from trees, metal objects and electrical wiring. Cell
phones, cordless phones, or other radio devices near
the Indoor Intercom may also limit range.
Indoor Intercom beeps once every ten minutes.
The battery is low in the Indoor Intercom. Replace
with AA Alkaline batteries or operate it with AC
Adapter (not provided). A 9-12 volt, 500mA AC
Adapter may be used (center positive polarity on the
round plug).
Indoor Intercom beeps three times every ten
minutes.
The battery is low in the Outdoor Intercom. Replace
with AA Alkaline batteries.
Need to clear Indoor Intercom’s memory.
Press and hold Learn button, an initial beep will be
heard. Continue to hold until a second beep is heard
(about 15 seconds). Ensure other intercoms are not
activated during this time. Intercoms in the network
that are on will signal during the clearing process.
Once memory is clear the intercom can be
programmed to a new network.
Outdoor Intercom does not function.
Check batteries in Outdoor Intercom. When you press
the Call button you should hear a tone.
Ensure Outdoor Intercom is connected to a network.
Program Additional Intercoms
NOTE: Some older versions of Chamberlain Wireless
Intercoms are not compatible with the Gate Access
Intercom. Ensure that the additional intercoms state
that they are compatible with Chamberlain's Gate
Access Intercom.
The Indoor Intercom can be programmed to at least
one other intercom to become a network or it can be
programmed into an existing network. Any intercom
that has been programmed into the network can
respond to a call and operate the gate.
INTERCOM LEARN MODE
Press the Learn
button until a beep is
heard.
Press and hold
both buttons for 5
seconds.
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form a
separate network and the memory will need to be
cleared.
Press the Learn button on the Indoor Intercom until a
beep is heard. Within 10 seconds put the new
intercom into Learn Mode (refer to table below).
Press and release the Talk button on the Indoor
Intercom to verify network is complete.