CFM Corporation Winter Warm - Small Insert User Manual

Page 8

WinterWarm Small Insert

2000888

3. Install the Chimney Connector Starter Pipe. (Not

supplied)

•

Mark and drill two 5/16”, (8 mm) holes 1⁵⁄₈” (41
mm) from the lower edge of the pipe. Locate the
holes on an axis that will be perpendicular to the
ﬁreplace opening when the pipe is installed. (Fig.
6)

•

Install the threaded rod (A), into the starter pipe
using washers and hex nuts (B,C),on the outside
of the pipe. Tighten the nuts, but do not distort the
pipe opening. (Fig. 6)

•

Secure the starter pipe to the chimney connector.
(Fig. 7)

4. Install the Floor Protector. Make sure the ﬂoor pro-

tector satisﬁes the requirements discussed on Page
6.

5. Install the Optional Outside Air Adapter. Follow

the instructions provided with the kit.

6. Install the Optional Surround Kit. Follow the in-

structions provided with the kit.

7. Slide the Firebox into Position. At least two people

will be needed to move the ﬁrebox. Position the
ﬁrebox so the ﬂue collar lines up with the connector.
Use the leveling screws at the front of the Insert to
adjust the level. Route the power cord to the side
nearest the power supply and test the fans.

1��"

(35mm)

FP1097
WWsi
starter pipe
4/3/01 djt

FP1097

Fireplace
Front

Fig. 8 Install the threaded rod inside the Starter Pipe (not a
supplied item, starter pipe is available from the Chimney Con-
nector manufacturer).

8. Join the Chimney Connector to the Flue Collar.

•

Assemble the draw-down hook and bar (D,E,F).

•

From inside the ﬁrebox, reach up through the ﬂue
collar and engage the hook over the threaded
rod inside the starter pipe. Position the steel bar
behind the two tabs within the ﬂue collar and then
turn the wing nut clockwise to draw the starter
pipe down. (Fig. 7)

9. Connect the Blower power cord to the power

supply.

This completes installation of your WinterWarm Small
Insert.

FP1098

pipes to cabinet

4/01

Seat the Starter

Pipe on the two

tabs inside the ﬂue

collar

Starter Pipe

Draw-down

Bar Assem-

bly

FP1098

Fig. 7 Attach starter pipe to ﬂue collar.