Climadiff VSV120 - Manual (Page 22)

22
4. INSTALLATION INSTRUCTIONS
Before using your wine cellar
•
Remove the inner and outer packaging.
•
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the
possibility of malfunction of the refrigeration circuit due to transport.
•
Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar:
Your wine cellar must be positioned in a room with an ambient temperature between 16 and 32°C.
If the ambient temperature is higher or lower, the performance of your appliance may be affected and it may not
be possible to obtain temperatures between 4 and 18 degrees.
Installing your wine cellar
•
This wine cellar is designed for free-standing installation.
•
Position it in a place with sufficient strength to support its weight when loaded.
•
To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
•
Connect the cellar to a single socket, leaving a 10 cm gap between the back of the cellar and the wall.
Ensure that your wine cellar is perfectly horizontal, then slightly raise the two front feet. (Use of a spirit
level is recommended). This will prevent any movement due to instability, causing noise and vibration,
and will ensure that the door seals perfectly.
Control panel