BoonDocker POLARIS RZR XP 1000 Control Box Install - Manual (Page 4)

RZR 1000 Control Box Installation
Page 4 of 6
03/26/14 www.boondockers.com
TPS installation
1. Locate the Throttle Position Sensor Connector.
2. It is a 6 position connector located on the Clutch side of the Throttle Body.
3. The Posi-Tap connector will come pre-installed with a seal on the white wire.
4. Before tapping into the wire twist Posi-Tap connector 5 times clockwise. This will make the wire
end up straight when finished.
5. Tap the White wire to the Green Wire in position 3 on the TPS connector.
To make sure this is installed properly, when able to start the engine , go to the Stats screen and
view the TPS in the lower center of the screen. You should notice a change when the pedal is pressed.
Run 05
S
00
A
0.0
2100 tps34 79
F
°