BoonDocker KTM XC-W: 450/500 Box Installation User Manual
Page 2
Revised 1/24/2014
Page 2 of ?
www.boondockers.com……………….....
……….………………....877-522-7805
1. Route harness through handlebars and along
stock wire harness. Mount control box to the
handle bars.
2. Air temp adaptor plugs to the intercooler
mounted air temp sensor
3. The Wastegate solenoid connector plugs into
the boost solenoid and has a Violet/white and
Red wire.
4. Install EFI connectors between the injector
and the factory injector harness.
Note: this connection is hard to get to without
taking off the throttle bodies.
5. Install Boondocker TPS harness between the
Throttle Position Sensor and the factory harness.
6. Route green wire above stock wire harness
under the frame to the spark plug wire. Wrap
around 10 times. Cut off excess wire.