Catler KE 4013 - Manual (Page 8)

6
OPERATING YOUR CORDFREE KETTLE KE 4013
OPERATING YOUR CORDFREE KETTLE KE 4013
Before fi rst use
Remove any promotional material attached
to your kettle. It is recommended that
before the fi rst use the kettle is fi lled to the
maximum level, boiled and water discarded.
Your kettle will only operate when positioned
on the power base with the On/Off switch in
the On position. The kettle will automatically
switch off once the water has boiled.
Operation of your kettle
1.
To fi ll the kettle, remove it from the
power base and open the lid by pressing
the lid release button. Fill with the
desired amount of water. Always fi ll the
kettle between the minimum (250 ml)
and maximum (MAX 1000 ml) marks on
the water window. Too little water will
result in the kettle switching off before
the water has boiled.
2. Ensure that the lid is locked fi rmly into
place. Place the kettle fi rmly onto the
power base. Plug the power cord into
230 V power point and switch On.
3. Press the On/Off switch to the On
position. The power On light and the
water gauge will illuminate.
Always fi ll the kettle between the minimum
(Min) and the maximum (Max) marks on the
exterior of the kettle. Too little water will result
in the kettle switching “Off ” before the water
has boiled. Filling above the maximum mark
on the exterior of the kettle may result in boiling
water splashing from the kettle.
NOTE
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald.
Do not pour the water too quickly.
NOTE
The kettle will automatically switch Off once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when fi lled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
Do not run or use the kettle when empty.
Misuse of the appliance may cause its life.
The kettle may be stored on its power base
when not in use. The power point should
be switched off and the appliance plug
unplugged from the power when not in use.
THIS APPLIANCE IS DESIGNED FOR BOILING OF DRINKING QUALITY WATER ONLY.
NEVER USE TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID
SHOULD ALWAYS BE FIRMLY IN PLACE AND LOCKED INTO THE CLOSED POSITION
BEFORE USE.
DO NOT PRESS THE LID RELEASE BUTTON ON THE HANDLE TO OPEN THE LID
DURING AND AFTER OPERATION. THIS MAY RESULT IN BOILING WATER SPLASHING
FROM THE KETTLE. POUR OUT ALL THE HOT WATER FROM THE KETTLE BEFORE
OPENING THE LID TO REFILL.