Cobra Electronics 19 DX II - Manual (Page 8)

Your COBRA CB transceiver is specifically designed for the
environment encountered in mobile installations. The use of all solid
state circuitry and its light weight result in high reliability. Should a
failure occur, however, review the following, then if necessary replace
parts only with identical parts. Do not substitute. Refer to the
schematic diagram and parts list.
1.
Check connections to the source of power and make sure it is the
13.8 VDC required to operate your radio.
2.
Check the fuse in the DC power cord. The main power lead (red
wire) has a 2 Amp 3 AG type fuse installed. Use only the above
specified type and size fuse for maximum protection. Failure to do
so, will void the warranty.
3.
Make certain the microphone is properly plugged in.
4.
Make certain the antenna is properly connected and tuned for
minimum SWR. NOTE: COBRA antennas include full instructions
for tuning your antenna. If you’re still in doubt about the
procedure, contact the COBRA dealer from whom you purchased
your radio and antenna, for advice. If you hired an installer to
install your radio and antenna, contact him.
If you are unable to correct the problem, please contact your local
dealer.
Adjustment Warning
When making adjustments other than transmitter adjustments, be sure
to re-read applicable portions of this instruction manual to make
certain you are following correct procedure and that the radio was
properly installed, etc.
12
Maintenance and Adjustment
Citizens Band radio operators have largely adopted the “10-code”
for standard questions and answers. Its use permits faster
communications and better understanding in noisy areas. The
following table lists some of the more common codes and their
meanings:
10-CODE
Code Meaning Code Meaning
10-1 Receiving poorly 10-35 Confidential information
10-2 Receiving well 10-36 Correct time is
10-3 Stop transmitting 10-37 Wrecker needed at
10-4 OK, message received 10-38 Ambulance needed at
10-5 Relay message 10-39 Your message delivered
10-6 Busy, stand by 10-41 Please turn to channel
10-7 Out of service, leaving air 10-42 Traffic accident at
10-8 In service, subject to call 10-43 Traffic Tie up at
10-9 Repeat message 10-44 I have a message for you
10-10 Transmission completed, 10-45 All units within range
standing by please report
10-11 Talking too rapidly 10-50 Break channel
10-12 Visitors present 10-60 What is next message
number?
10-13 Advise Weather/Band 10-62 Unable to copy, use phone
conditions 10-63 Net directed to
10-16 Make pick up at 10-64 Net Clear
10-17 Urgent business 10-65 Awaiting your next
10-18 Anything for us? message/assignment
10-19 Nothing for you, return 10-67 All units comply
to base 10-70 Fire at
10-20 My location is 10-71 Proceed with transmission
10-21 Call by telephone in sequence
10-22 Report in person to 10-77 Negative contact
10-23 Stand by 10-81 Reserve hotel room for
10-24 Completed last assignment 10-82 Reserve room for
10-25 Can you contact 10-84 My telephone number is
10-26 Disregard last information 10-85 My address is
10-27 I am moving to channel 10-91 Talk closer to mike
10-28 Identify your station 10-93 Check my frequency on
10-29 Time is up for contact this channel
10-30 Does not conform to FCC rules10-94 Please give me a long count
10-32 I will give you a radio check 10-99 Mission completed, all
10-33 EMERGENCY TRAFFIC
units secure
10-34 Trouble at this station 10-200 Police needed at
13
Appendix