CASO Germany WineMaster Touch 38-2D (652) - Manual (Page 35)

caso WineMaster Touch 35
14 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
14.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
14.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault Possible Cause
Wine refrigerator do not operate. Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Wine refrigerator is not cold
enough. Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
The light does not work. Check the service center.
Vibrations. Check to assure that the wine refrigerator is level.
The wine refrigerator seems to
make to much noise The wine refrigerator is not level.
Check the fan.
The door will not close properly. The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak.
The shaves out of position.
LED could not display. Main control board does not work.
PCB Problem.
There is some problem with the plug.
LED display error - Lo Weak quality of display.
Temperature point is out off. Check the service center.