CASO Germany Vario Power 3400 Magenta (2252) - Manual (Page 41)

caso Vario Power 3400 41
Warning
► In order to prevent overheating do not place any aluminium foil or metal panels on the
appliance surface.
► Do not touch the hot surface of the ceramic hob.
Although the induction cooktop itself does not produce any heat during the cooking
process, the temperature of the cookware does heat up the hob.
► Keep the hob and the underside of the pot clean and dry at all times. If liquid gets
between the base of the pot and the hob, this liquid can vaporise and the resulting
pressure can cause the pot to jump into the air, with a resulting risk of injury.
► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the
appliance be unplugged from the mains.
13.4 Operating the Appliance
13.4.1 Switching On
• Plug the power plug into a suitable outlet.
• The temperature of the cooker plate surface displayed: is the temperature of the surface
of the induction cooker lower than 50°C, the display shows „L“. When the temperature
of the cooker plate surface is over 50 °C, it is displaying „H“. An acoustic signal sounds.
Now the device is in standby mode.
• Place a suitable cooking pot with its contents to be cooked on the centre on the hob (Ø
160 mm - 260 mm).
• Now press the On/Standby switch 1 to turn on of the two induction hotplates on. The
control lamp "Power" and “Temp” blink and an acoustic signal sounds.
► When the device heats up in operation due to the pot, the colour of the glass ceramics
can get a little bit darker.
► After cooling down, the glass ceramics is in its original colouring.
13.4.2 Power Mode
• Press the Function Key 3. The preset power stage "8" is selected and the device turns
on. With the + / - Keys (5+6), you can change the settings at any time in a range from 1
– 12.
Please note
► We recommend to select the function “Power Mode” in case of steaming food or boiling
water for example. So the overheating protection “E05” will not be activated.