Maintenance, Inspire electric fireplace – CFM Corporation ICVCEFP01 User Manual

Page 9

Inspire Electric Fireplace

10009472

Glass Information

1. Never strike or slam the glass.
2. Never use abrasive cleaners to clean the glass.
3. Never attempt to operate this ﬁreplace if any glass

component is broken.

4. Always utilize a qualiﬁed service technician to re-

place broken glass components and always install
genuine CFM Corporation tempered glass replace-
ments, which are available from your authorized
dealer.

Care and Cleaning

Always disconnect the appliance from the main power
supply and allow to cool before any cleaning operation.
Metal painted parts may be cleaned using a clean,
damp cloth. Never use any abrasive cleaners and
chemical agents as these may damage the paint ﬁnish.
Cleaning of the screen diffuser is to be done using only
water and a lint free cloth. DO NOT use any abrasive
household cleaners as these products will damage the
diffusing screen.

Maintenance

Always disconnect the ﬁreplace from the main
power supply before performing any routine main-
tenance. Always utilize a qualiﬁed technician if
assistance is required.
Always install genuine CFM Corporation replace-
ment parts, which are available from your autho-
rized dealer.

��
��
��

Light Bulb

Color Film

FP1643

Fig. 7 Remove color ﬁlm and remove light bulbs.

��
��
��

Fig. 6 Removable panel.

Removable Panel

FP1640

Remove Screws

WARNING

NOTICE

Always use the recommended 20 watt compact
ﬂuorescent light bulbs. Never install incandescent
light bulbs in this ﬁreplace.
It is advisable to use genuine CFM Corporation replace-
ment parts available from your authorized dealer.

Light Bulb Replacement

1. Disconnect the appliance from the main power sup-

ply.

2. Remove the decorative trim assembly.
3. Remove the pebbles and ember bed.
4. Remove the removable panel by unscrewing the four

(4) screws. (Fig. 6)

5. Remove the colored ﬁlter from the bulb and unscrew

the bulb from its housing. (Fig. 7)

6. Install the new 20W light bulb.
7. Reassemble in reverse order.

CAUTION

Service

Always disconnect the appliance from the main power
supply and allow it to cool before any servicing opera-
tion.
The motors used on the fan heater and ﬂame blower
are pre-lubricated for extended bearing life and require
no further lubrication. However, periodic cleaning/vacu-
uming of the appliance and around the air intake and
exhaust is recommended.