LG L8010ER - Manual (Page 17)

Operating Instructions
Operating Instructions
V
V
I In fai
POWER 3 )
Operation starts when this button is pressed and
stops when you press the button again.
FAN SPEED SELECTOR
For increased power while cooling, select a higher
fan speed. 3 steps: High —Low—Med
ON/OFF TIMER
The timer can be set to start and stop the unit in
hourly increments (up to 12 hours).
You wiii usuaiiy use shut-off time whiie you sieep.
For your sleeping comfort, once timer is set, the temperature setting
wiii raise 2°F after 30min and once again after another 30min.
OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select energy saver mode for energy saving operation.
Select fan mode for basic ventilating fan operation.
Select dry mode for dry operation.
Dry mode is used to remove humidity from the room without additional cooling.
Once the set temperature is reached, the compressor and circulation fan turns
off. Fan speed is pre-set and cannot be adjusted.
TEMPERATURE CONTROL
The thermostat monitors room temperature to
maintain the desired temperature.
The thermostat can be set between 60°F~86°F
(16°C~30°C).
The unit takes an average of 30 minutes to adjust the
room temperature by TF.
REMOTE CONTROL SENSOR
mEmm
In failure of electric power, the unit runs as previous setting operation.
Owner's Manual 17