To replace fuse (see fig. 27), To remove hood and grill (see fig. 28), To replace headlight bulb – Craftsman 917.255561 User Manual

Page 22: Interlocks and relays, Interlocks and relays .. .............. ,-22, Service and adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SERVICE AND ADJUSTMENTS

TO REPLACE FUSE (See Fig. 27)

Replace with 30 amp automotive-type piug-in fuse, The

fuse holder is located in the engine compartment, directly

in front of the dash.

TO REMOVE HOOD AND GRILL (See Fig. 28)

TO REPLACE HEADLIGHT BULB

•

Raise hood.

•

Pull bulb holder out of the hole in the backside of the

grill.

. Replace bulb In holder and push bulb holder securely

back into the hole in the backside of the grill,

•

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting

•

Check wiring. See the electrical wiring diagram in the

Repair Parts section of this manual,

CAUTION: Muffler is hot. Be careful
when removing retainer springs from
hood pivot brackets.

Raise hood.

Unsnap headlight wire connector.

Remove retainer springs from hood pivot brackets.

Stand in front of tractor. Grasp hood at sides, tilt

forward and lift off of tractor

To reinstall, slide hood pivot brackets into slots in
frame. Replace retainer springs.

Reconnect headlight wire connector and close hood.