beautypg.com

Clean air screen, Muffler, Spark plug(s) – Craftsman 917.273170 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

AiR

filter

Your engine will not run properly using a

dirty air filter. Clean the foam pre-cleaner
after every 25 hours of operation or every
season. Service paper cartridge every

100 hours of operation or every season,

whichever occurs first.

Service air cleaner more often under dusty
conditions.

1. Remove knob and cover.

2. Remove wing nut and air cleaner from

base.

TO SERVICE PRE-CLEANER

3. Slide foam pre-cleaner off cartridge.

4. Wash it in liquid detergent and water.

5. Squeeze it dry in a clean cloth. Allow it

to dry.

6. Saturate it in engine oil. Wrap it in

clean, absorbent cloth and squeeze to

remove excess oil.

TO SERVICE CARTRIDGE

1. Replace a dirty, bent, or damaged

cartridge.

NOTE: Do not wash the paper cartridge
or use pressurized air, as this will damage

the cartridge.
2. Reinstall the pre-cleaner (cleaned and

oiled) over the paper cartridge.

3. Reassemble air cleaner, wing nut,

cover and tighten knob securely.

Air Cleaner

^__ .Cover

Cover \

___Knob

Foam
Pre­
Cleaner

Wing Nut

Rubber

Grommet

Air

Screen

Cleaner

Paper

Cartridge

Air Cleaner
Base

■Oil Fill Cap/

Dipstick

CLEAN AiR SCREEN

Air screen must be kept free of dirt and

chaff to prevent engine damage from
overheating. Clean with a wire brush or
compressed air to remove dirt and stub­
born dried gum fibers.

MUFFLER
inspect and replace corroded muffler and
spark arrester (if equipped) as it could cre­
ate a fire hazard and/or damage.
SPARK PLUG(S)
Replace spark plug(s) at the beginning
of each mowing season or after every

100 hours of operation, whichever occurs

first. Spark plug type and gap setting are

shown in “PRODUCT SPECIFICATIONS”
section of this manual.

in

-

line

fuel

filter

The fuel filter should be replaced once

each season, if fue! filter becomes
clogged, obstructing fuel flow to carbu­
retor, replacement is required.

1. With engine cool, remove filter and

plug fue! line sections.

2. Place new fuel filter in position in fuel

line with arrow pointing towards carbu­
retor.

3. Be sure there are no fuel line leaks

and clamps are properly positioned.

4. Immediately wipe up any spilled gaso­

line.

Clamp

Clamp

Fuel Filter

CLEANING

• Clean engine, battery, seat, finish, etc.

of all foreign matter.

• Keep finished surfaces and wheels free

of all gasoline, oil, etc.

• Protect painted surfaces with auto­

motive type wax.

We do not recommend using a garden

hose or pressure washer to clean your

tractor unless the engine and transmis­

sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.

20