Craftsman 247.795861 - Manual (Page 5)

ASSEMBLY INSTRUCTIONS
il
Flat
Washer
5/16" I.D
-^Hex Lock
Nut 5/16-18
Thread
Hex Bolt
'5/16-18x8-3/8" Long
IMPORTANT: This unit is shipped WITHOUT GASO­
LINE or OIL After assembly, see operation section of
this manual for proper fuel and engine oil recommen­
dations.
NOTE: To determine right and left hand sides of your
chipper-shredder, stand behind and face the hopper
(engine is at the front of the unit).
Your chipper-shredder has been completely assem­
bled at the factory, except for the hopper assembly
(hopper hood and upper leaf ramp section have been
sub-assembled), upper guide assembly, chute deflec­
tor and the catcher bag The hardware pack and safe­
ty glasses are also included in the carton
The hardware pack contains the parts shown in figure
1 (shown full size)
TO REMOVE CHIPPER-SHREDDER FROM CARTON
Cut the corners of the carton. Remove all packing
inserts. Roll chipper-shredder out of the carton Make
certain all parts and literature have been removed
before the carton is discarded
TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver
(2) 1/2" or Adjustable Wrenches
(2) 7/16" or Adjustable Wrenches
Truss Machine Screws
1/4-20
X
1/2" Long
Hex Lock Nuts
1/4-20 Thread
FIGURE 1 .