Craftsman 247.370253 - Manual (Page 14)

from the adapter for the best test of bale nee. surface of the wheel with light oil. See figure 14.
If you are reassembling the blade and the blade
adapter to the unit, lubricate the motor shaft and
the inner surface of the blade adapter with light
oil (or engine oil). See figure 14.
Also lubricate the bolt holes, bolts and inner
surface of the nuts in the blade adapter
assembly before reassembly. See figure 14.
Figure 13
• When replacing the blade, be sure to in stall the
blade with the side of the blade marked Bottom”
(or with part number) facing the ground when
the mower is in the operating position. >Jso
make sure to follow the correct order as shown
in figure 12.
3. DECK
NOTE: The underside of mower deck shoulibe
cleaned after each use as grass clippings, le ives, dirt
and other matter will accumulate. This accur nutation
of grass clippings, etc., is undesirable as it w ill
promote rust and corrosion.
•
Remove any buildup of grass and leave is on or
around the motor cover (do not use wat sr). Wipe
mower clean with a dry cloth occasiona lly.
• Disconnect the power source. Tilt the n lower
forward or on its side and scrape clean with a
suitable tool.
A WARNING: To reduce the risk of electric
shock, do not expose mower to wa er.
4. LUBRICATION
Refer to Lubrication Chart in the next columi i.
• Keep unit well lubricated. Lubricate the springs
on the rear discharge door with a light ( lil. See
figure 14.
• Lubricate the bolts holding the height
adjustment lever to the deck with a ligh t oil. See
figure 14.
• If the wheels are removed for any reas )n,
lubricate the surface of the axle and th< i Inner
Figure 14 - Lubrication Chart
14