Craftsman 351.223130 - Manual (Page 4)

• If this system is used with other dust collectors, the dust
collector must be rated at least 3 V 2 " (of water) static pressure
and 150 cfm at 2 V 2 " diameter. A reducer may be needed.
• This system is not intended to be used with a wet/dry vac.
DANGER: Do not use this dust collection system in a
flammable or explosive atmosphere. Do not use to collect
metal shavings or dust Consult National Fire Protection
Association (NFPA) standards before setting up a dust collec­
tion system, especially NFPA 664,
WARNING: Do not connect to dust collector until unit is
completely assembled.
CAUTION: Improper connection of the equipment-grounding
conductor can result in a risk of electrical shock.
Open blast gate of machine which will be used. Close all
other blast gates.
Turn dust collector power switch to ON.
Turn woodworking machine power switch to ON.
MAINTENANCE
Refer to Figure 2.
WARNING: Turn dust collector switch off and remove plug
from power source outlet before maintaining your shop dust
collection system.
Clean inside the pipes, fittings and flexible hose using a portable
vacuum cleaner or manually remove large debris as needed.
Model 351.223130
0
REPLACEMENT PARTS LIST FOR DUST COLLECTION SYSTEM
KEY
NO. PART NO. DESCRIPTION QTY.
1 23967.00 2 V 2 X 24” Flexible Hose 1
2 23968.00 Connector 12
3 23969.00 45° Elbow - 2 V 2 " 2
4 23970.00 2 V 2 X 22" Plastic Straight Pipe 4
5 23971.00 Hanger 8
6 23972,00 2 V 2 " Plastic “T” Fitting 3
7 23973.00 Blast Gate 4
8 23974.00 2 V 2 " Hose Clamp 10
9 23975.00 2 V 2 X 72” Flexible Hose 4
10 23976.00 Mounting Hardware Kit 1
11 23977.00 Grounding Kit 1
A 23964.00 ID/Warning Label 1
A 23961.01 Operator’s Manual 1
A Not Shown