To adjust cutting height, Rear deflector, To remove/replace drive belt (see fig. 14) – Craftsman 917.37459 User Manual
Page 15: Service and adjustments, Lawn mower
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
A
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
.
» Release control bar.
•
Make sure the blade and all moving parts have completely stopped.
•
Disconnect spark plug wire
from
spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of
your lawn mower, is provided to minimize the possibility
that objects will be thrown out the rear of the lawn mower
into the operator's mowing position. If the rear deflector
becomes damaged, it should be replaced.
TO REMOVE/REPLACE DRIVE BELT
(See Fig. 14)
" Remove drive cover. Remove belt by pushing down on
gear case pulley.
*
Turn lawn mower on its side with carburetor and fuel
cap up.
“ Remove blade.
» Remove debris shield.
® Remove belt from engine pulley on crankshaft.
*
Install new belt by reversing above steps.
« Always use factory approved belt to assure fit and long
life.
FIG. 14
15